Simrad FS25 Uživatelská příručka stáhnout pdf (Strana 41)

901-10037001/1.1 FS 20/25 Operators Manual

Page 4.4 FS 20/25 Installation, System Set-Up and Test

Kongsberg Simrad Mesotech Ltd.

Port Coquitlam, BC - Canada

Optional equipment for interface to the control unit may be mounted in any convenient

location provided the user supplied interconnect cables are of sufficient length and the

required power is available.

4.2.2 Power Considerations

The display unit, generally, will require 110 VAC or 220 VAC. Depending on the

capabilities of the unit chosen, it may automatically detect the supply voltage or the

unit may have to be ordered for the correct voltage.

The FS 20/25 HP PC processor will operate from either 110 VAC or 220 VAC. Voltage

selection must be selected, a voltage input selector switch is located at the rear of the

unit. Failure to select the proper Input voltage will damage the internal power supply

The FS 20/25 Power Supply/TTM module can be operated with either 110 VAC or 220

VAC. Selection of the supply voltage is done by moving the voltage selector card

located in the power entry module at the rear panel. Details on selecting the proper

voltage are indicated on the voltage card. You must position the “indicator pin” location

to the desired voltage. The safety fuses must also be changed to the proper rating.

Refer to Paragraph 4.2.7 for more detail.

4.2.3 Connecting a Display Unit

Either a VGA monitor CRT type or a Simrad LCD monitor may be connected to the

FS 20/25 HP PC processor. Depending on which type of monitor is used, the video

output type must be set accordingly.

An industry standard VGA monitor will connect directly to the miniature DB-15

connector located on the rear panel of the control unit.

The FS20/25 HP PC has a DualHead video interface card installed as standard

equipment. You must set up your display software as per your requirement. If you

have only one monitor, simply plug your monitor cable into the monitor connector

marked “Connector 1” on the adapter card, or Video “A” port. If you are using two

monitors, you must connect the 2

monitor in the “Connector 2” on the adapter card,

or Video “B” port.

Note: The FS20/25 HP PC must be is turned “OFF” prior connecting the video

monitors

An HP User Guide manual is provided with the system, including a Recovery CD-

ROM. With this CD you can recover your system as delivered, run HP diagnostics.

Note: The DualHead software is installed at the factory, you only have to set up your

monitor configuration as per Window’s 2000. See Part 7 “Attachment” for set-up

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 107 108

Žádné komentáře

Simrad FS25 Uživatelská příručka Strana 41